Monarcoat Rapid & Monarcoat Rapid Ultra
The Monarcoat Rapid products are high-build Polyaspartic fast –cure floor coating systems based on advanced materials, designed to provide a transparent tough and durable gloss finish to a range of floor surfaces. Monarcoat Rapid and Monarcoat rapid Ultra are light stable with a very good chemical resistance, Decorative and anti-slip finishes can also be created incorporating flakes and aggregates.
- Fast curing at low temperature (very fast for Monarcoat Ultra Rapid)
- High build
- UV stable
- Very low odour
- Tough but flexible
- Can be applied onto a wide range of substrates
- Can be used in decorative and functional environments
- No VOC
- Where a high-build UV stable coloured top-coat/seal coat required
- Areas where fast turnaround but high performance finishes are required
- Domestic, commercial and Industrial
- Decorative floors
Supplied in 5kg units
Floors must be clean, sound, dry and fully cured and surface laitance removed, preferably by shot blasting or mechanical abrasion.
Concrete Floors: Concrete must be clean, sound, dry and fully cured and surface laitance removed preferably by enclosed shot blasting or mechanical grinding, a minimum strength of 25N/mm² is required
Monarcoat Rapid may be applied direct to concrete or as a seal coat to resin floor systems where a primer is not required. When applied direct to porous substances the surface may require priming. Dry surfaces should be primed with MonarprimeDPM. Where the relative humidity moisture content above 75% Monarprime DPM should be used. The number coats required will be dictated by the relative humidity of the substrate.
It is important to ensure that stated recoat times are observed. This will ensure intercoat adhesion.
FeRFA Category: 2/3