Epoxy Resin Flooring


Monardeck is a resin based car park decking system designed to provide a coating system suitable for vehicular and pedestrian usage in exposed and enclosed conditions.


Monardeck I.L.monardeck
Monardeck Intermediate Level car park decking is a resin based flooring system for intermediate decks. It provides a floor which will withstand motor fuel emissions and salts, and provide an anti-slip, low-maintenance floor which will withstand vehicular and pedestrian trafficking.
Monardeck T.L.P.
Monardeck Top Level Parking provides all of the qualities of the Monardeck I.L. It also provides an elastomeric waterproof floor, preventing ingress of moisture to lower levels. This system can also be used as a roofing system and for other waterproofing installations.


Mix components A and B together in a suitable mixer e.g., Creteangle, Mixal or with a low speed drill and non air-extraining paddle. Add aggregate pack C (Monardeck only) whilst mixing then continue mixing for 4 minutes until homogeneous. Care should be taken to ensure that the bottom and sides of mixing vessels are thoroughly scraped.

Method of Use

Surface preparation – see requirements of preparation data sheet.

Apply to cementitious and Asphalt substrates.

All cementitious surfaces to be cured to 75% Relative Humidity. Vacuum shot-blasting or diamond grinding is preferred on all smooth/or dense surfaces.


To provide a waterproof surface all expansion joints should be masked and ‘striped’ with 100mm overlap of Monarflex Elastomeric prior to application of 2nd coat (in TLP specification only). All bolt fixings should be carried out with proprietary chemical fixings to avoid disruption of waterproof membrane

Data Sheet

Monardeck I.L.

1st Coat Monarprime Epoxy resin primer - apply by squeegee and roller @ 30-40m²/10kg unit - blind whilst uncured with quartz aggregate 0.4mm-0.8mm @ 3kg/m²
2nd Coat Monardeck Applied by squeegee and roller @ 0.7kg/m²

Monardeck T.L.P.

1st Coat Monarprime Epoxy resin primer - apply by squeegee and roller @ 30-40m²/10kg unit
2nd Coat Monarflex Elastomeric membrane coating applied by squeegee @ 1.4-1.8kg/m²
3rd Coat Monardeck Applied by trowel/squeegee @ 2kg/m². Whilst uncured cast in quartz aggregate 0.7mm-1.2mm @ 3kg/m² until full saturation.
4th Coat Monardeck Applied by squeegee and roller @ 0.7kg/m²

System properties for T.L.P.

Elongation at break 70%
Shore ‘D’ hardness 60
Tensile Strength 7N/mm²
Compressive Strength 90N/mm²
Widthways Movement Maximum widthways movement of structure 3mm. Above this figure suitable movement joints should be employed.

Down Arrow Up Arrow twitter Facebook Google Plus Linkedin instagram Left Leaves Right Leaves